Palo/Jedox 3.3 ODBC via DSN stopped working

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Palo/Jedox 3.3 ODBC via DSN stopped working

    Hi,

    I just attempted an upgrade from 3.2 to 3.3. All went well until I tried to reload the cubes via ODBC/DSN. Palo complains about an "architecture mismatch between the driver and the application". The box is 64bit, but the office installation (and thus Access) are 32bit and the DSN was setup with obdcad32.

    Any hints?
    Best regards
    Tuomo Takkula