RoadShow 2016 Workflow report

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • RoadShow 2016 Workflow report

    Does Any one here familiar how to properly configured RS2016 workflow report?
    I have followed necessary steps in the manual and even created new workflow task but it doesn't load proper function as expected.
    Whenever I start the task it just shows this report (named "Capture.png" from the attached) without anything inside.
    Where i should show from the attached named "Capture2.png".

    Anyone here experience the same when they install RS2016 and load the same report?

    Thanks
    Images
    • Capture.PNG

      19.86 kB, 842×391, viewed 120 times
    • Capture2.PNG

      132.94 kB, 688×398, viewed 103 times